An experienced Altium user solved this problem using FILLs applied to the soldermask layer as shown below. The result is soldermask squares that tented the VIAs.
Single layer mode - 3D View of the Soldermask
Thursday, March 28, 2013
Soldermask Dots
I recently had a design where I needed soldermask dots on a thermal pad as shown below.
An experienced Altium user solved this problem using FILLs applied to the soldermask layer as shown below. The result is soldermask squares that tented the VIAs.
Single layer mode - 3D View of the Soldermask
An experienced Altium user solved this problem using FILLs applied to the soldermask layer as shown below. The result is soldermask squares that tented the VIAs.
Single layer mode - 3D View of the Soldermask
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment