This library part has soldermask defined pads.
The clearance violations are due to the soldermask defined pads (where soldermask swell is less than the pad size) .
Out of the box rule shown below.
Click on image to view.
Work Around:
Check Clearance to Solder Mask Openings
And use:
(IsText OR IsTrack OR IsArc OR IsFill)
OnTopSolderMask Or OnBottomSolderMask
As shown above I used a 3 mil Clearance rule. If the soldermask swell is 4 mil then this would be the same as a silkscreen to pad clearance rule of 7 mils.
That's It !
No comments:
Post a Comment